THC Vape spare parts explained guide
There is no shortage of suppliers quoting THC vape. The scarce thing is a supplier who will tell you which SKU to drop. We have been shipping THC vape products long enough to know that the honest answer is usually a shorter list, and that is the answer we give.
Published 19 November 2024 · VapeWholesaleHub · Reading time 5 min
Sell-through notes for the shop floor
We work with dropshippers who order between a few hundred and a few thousand units at a time, and we treat both ends the same way: a written specification, a sample you approve, and a production run that matches the sample.
Staff knowledge converts better than any poster. If your team can explain the difference between two coils in one sentence, the step-up SKU sells itself.
Seasonality in THC vape products is real but smaller than most buyers assume. The bigger swing comes from restocking discipline, not from calendar events.
Labels, closures and traceability
If you sell into a market that requires child-resistant packaging, say so at quotation stage. Retrofitting a CR closure onto a finished bottle design usually means a new mould and a four week delay.
Regulation for THC vape products differs by country and sometimes by state. We do not pretend to be your lawyer, but we do keep the document pack current and we will tell you when a configuration cannot legally enter a market you have named.
What we test before a carton is sealed
Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.
Cosmetic grading is written down, not argued about. Minor scuffs inside the tolerance band are accepted; anything that would make a customer put the unit back on the shelf is rejected. Your staff should never have to explain a finish defect to a paying customer.
- Document pack prepared per destination market
- Batch codes traceable from carton back to production date
- Cartons drop-tested and pallet-counted for clean freight
- Consolidated or split shipping, quoted both ways
- Standing reorder schedule with a fixed cut-off
- Named account contact who has handled the product
Where the margin really sits
We publish a realistic band of 3.31 to 9.81 per unit for standard configurations at 60 units. Below that band you are buying a lighter specification; above it you are paying for finish, packaging or a smaller run.
A landed cost sheet for THC vape has five lines: unit price, packaging, freight, duty and the cost of defects. Quoting only the first line is how buyers end up surprised at the fourth.
Specification summary
| Volume | 0.5 ml |
| Hardware | Ceramic core |
| Thread | Proprietary pod |
| Airflow | Fixed |
| Window | Side window |
| Packaging | Blister |
| Minimum order | 200 units per SKU, mixed cartons allowed |
| Lead time | 25 working days after artwork approval |
None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.
Frequently asked
What happens if part of the order is defective?
Report within seven days with photos and the batch code. Confirmed defects are replaced or credited on the next shipment. The failure is logged by mode and batch, and reviewed monthly with the factory.
What is the minimum order for THC vape?
Standard configurations start at 60 units per SKU, with mixed SKUs allowed inside the same carton. Custom colours, custom packaging or a private label run usually start at 240 units because of setup time on the line.
How do you handle repeat orders?
The specification is held on file against your account, so a reorder is a reference rather than a new brief. We recommend a standing schedule with a fixed weekly cut-off so stock lands before the shelf empties.
Related reading
Need a quotation on THC vape products?
Send destination market, target price and quantity. Same-day reply on working days.
Tel / WeChat / WhatsApp +86 13711127975 · vape@0099933.xyz