THC Vape sample refund primer

Choosing the core line

A THC vape programme only works when three numbers agree: your shelf price, your reorder cycle and your defect tolerance. Change one and the plan moves. We build assortments around those three and we say so up front rather than after the invoice.

Factory capacity matters more than factory size. A line that can hold a tolerance across 5,000 units is worth more than a showroom that can produce 50,000 on paper. We qualify capacity by running a repeat order and measuring the drift.

A practical starting order for dropshippers is 200 units across two or three SKUs, not 200 units of one. That spreads the risk, gives your staff something to compare, and still hits the first price break.

Merchandising a small range well

Shelf position decides velocity as much as price. Keep THC vape products at eye level, one facing per SKU, and rotate the trial line every quarter so the display keeps earning attention.

Counter space is finite. Three well-chosen SKUs outsell nine crowded ones, and the empty space signals a curated range rather than a clearance table.

Reading a quotation properly

Payment terms for new accounts are normally a deposit with the balance against the bill of lading. Established buyers on a repeat schedule can move to terms after three clean shipments.

The cheapest way to lower your cost per unit is usually to remove a SKU, not to negotiate a discount. Fewer lines means larger runs, fewer changeovers and a better price at the same quality.

• Specification locked in writing before production starts
• Batch codes traceable from carton back to production date
• Cartons drop-tested and pallet-counted for clean freight
• Reference sample retained from every batch
• Artwork proof plus physical dummy for custom packaging
• Consolidated or split shipping, quoted both ways

What we test before a carton is sealed

Cosmetic grading is written down, not argued about. Minor scuffs inside the tolerance band are accepted; anything that would make a customer put the unit back on the shelf is rejected. Your staff should never have to explain a finish defect to a paying customer.

Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.

Specification summary

If any of this is unclear, the fastest route is a message rather than a meeting. Send the market you sell into and the price band you work in, and you will get a specific answer instead of a brochure.

Frequently asked

Related reading

Tel / WeChat / WhatsApp +86 13711127975  ·  vape@0099933.xyz